Crestron DIN-1DIMU4 Uživatelský manuál

SECTION 260933 (previously 16575) Central Lighting and Dimming Controls PART 1 - GENERAL 1.1 SUMMARY: A. Work Included: The work of this Sectio

4) neon/ cold cathode 5) Advance Mark X Ballasts b. Dimming Control 120vAC to 277vAC: 3-Wire 20amp 120 to 277vAC Expansion Module, supporting up

A. The Manufacturer shall provide the services of a qualified factory-employed field service engineer for a minimum of one (1) pre-wire visit and ins

c. Provision of manufacture of Low-voltage fixtures including model number and type of transformer 1.3 SUBMITTAL REQUIREMENTS A. Submittals for Rev

c. Contact information for 24 hour a day, 7 day a week, 365 day a year technical support hotline. 3. As-Built System Drawings, including: a. Shop d

a. Evidence of compliance with Manufacturer Qualifications as outlined below. b. A listing of three (3) equivalent installations including: 1) Name

4. Control Surfaces (preset controllers, touch panels and keypads) shall only be installed once the installation area is a “conditioned space”, as de

1. Relay modules shall have eight separate channels or circuits that can be independently controlled through the Cresnet system. Each circuit shall

2. Digital output: 250 mA sink from maximum 24VDC; catch diodes for use with “real world” loads. 3. Analog input: Rated for 0-10VDC, protected to

A. General: The Integrated Multi-Zone Controller(s) shall have, at a minimum, the following features: 1. Integrated phase-forward dimming, switchin

1. Connection to touch panels for custom interfaces, programming, preset recall, system state selection, and room combine/ partitioning functions. 2.