Crestron CT-3000 Specifikace stáhnout pdf (Strana 12)

Crestron e-control Database Manager SW-DBM

12 •• Basic Server Setup Installation & Reference Guide — DOC. 5823

The installer registers demoDBM.ini as the currently selected Configuration

Settings file. (If the server’s title bar does not read “e-control Database Manager

Demos,” use the File | Configuration file… command to reset it.) This file

configures the server for all three demos.

Each demo folder contains the following files:

Demo?COM.smw SIMPL Windows project file (RS-232 version)

Demo?TCP.smw SIMPL Windows project file (TCP/IP version)

demo?COM.bin compiled SIMPL program code (RS-232 version)

demo?TCP.bin compiled SIMPL program code (TCP/IP version)

RS-232 is featured in the Quick

Setup Guide because it is easy to

set up. Because we anticipate

strong interest in TCP/IP, we have

pre-built both versions for your

convenience.

In the above, ? stands for the demo number. The two versions of the SIMPL

program for each demo, (COM and TCP) are almost identical, both being

configured for a CNMSX-PRO, using the front panel device and a touchpanel with

CRESNET ID = 03. Both versions have ports defined for both serial (RS-232)

communications via the CNMSX-PRO’s built-in COM A port (slot 4, port A), and

EtherNet (TCP/IP) communications via the LAN port on a CNXENET card installed

in the CNMSX-PRO’s DPA slot. In the COM versions, the TCP/IP port is

commented off while in the TCP versions, the RS-232 port is commented off. This

is the only difference between the two versions.

The following sections separately describe the setup procedures for connecting

multiple control systems via either RS-232 or TCP/IP connections. Actually, a

mixture of connections is permitted. For example, two control system might be

connected via RS-232 (using the COM1 and COM2 ports) while two more might be

simultaneously connected via the TCP/IP network connection.

In the following, the indented, italicized paragraphs contain advice on setting up the

server and a control system specifically to run the supplied demo files. You will find that

most of the steps have already been accomplished because they are specified by the

supplied demo configurations.

Communications Setup

Server Side

1. Run server application by selecting Database Manager from the Crestron

folder of your Start menu.

2. Select config file. Specify a Configuration Settings file (.ini file) by selecting

File | Configuration File…. Refer to “Specifying a Configuration File,” page

16.

The server is installed with a demomail.ini pre-selected as the default

configuration file. (This is intended to simplify the Quick Start Guide.)

Set communications mode. Select Server | Configure and enter a password to open the

Configuration Options window. (Refer to “NOTE: If the server cannot open a specified configuration

file, it uses default values for all options. If any changes are made, a new config file is created using

the specified pathname when the OK or the Apply buttons are actuated

3. Password Access,” page 16). Select the COM Settings tab. The settings for

each connection to a control system must match those on the other end (the

control system side) of the actual connections. Click on each connection in

turn, click the Modify… button, and choose either RS-232 (and select the port

and speed) or TCP/IP (and set the IP address and IP ID). Click OK to make

the changes for each connection.

The demos are pre-configured to use RS-232.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 93 94

Komentáře k této Příručce

Žádné komentáře

Crestron CT-3000 Specifikace Strana 12

Komentáře k této Příručce