Crestron TPMC-10 Specifikace stáhnout pdf (Strana 21)

Crestron TPMC-10 Isys i/O

™

WiFi Touchpanel

Typical System Configurations

The following diagram illustrates a basic configuration that connects a TPMC-10

WiFi touchpanel to a control system via a wireless access point (WAP).

• The distance between the TPMC-10 and the dedicated WAP should not exceed

30 feet. The TPMC-10 is not a roaming device.

• Use a dedicated wireless router/access point for each TPMC-10 device.

• Each TPMC-10 must have only a single dedicated WAP listed in its Preferred

Networks list. Refer to the “

WiFi SETUP” instructions on page 13. Refer to the

Crestron website (www.crestron.com), online help answer ID 2488, for

recommended access points and configuration files.

The following diagram presents a more complex configuration. In this scenario, the

WAP is connected to an A/V subnet. Port B of the control system’s C2ENET-2 card

is also connected to the A/V subnet. Port A is connected to the corporate LAN. The

card’s internal firewall controls data flow thus isolating the two subnets.

NOTE: When using a dual-port Ethernet card, Ports A & B must be different

subnets (Port A = 192.168.1.1; Port B = 192.168.2.1).

For additional information on setting up and understanding an Ethernet network,

refer to Doc. 6052, Crestron e-Control Reference Guide. It may be downloaded from

the Crestron website (www.crestron.com/manuals)

Operations Guide – DOC. 6284C Isys i/O

™

WiFi Touchpanel: TPMC-10 • 17

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Žádné komentáře

Crestron TPMC-10 Specifikace Strana 21