Crestron CP2 Specifikace stáhnout pdf (Strana 26)

2-Series Integrated Control Processor Crestron CP2/CP2E

use a CAT5 crossover cable to connect the two LAN ports directly, without using a

hub.

Once the cable connections are made, open the Crestron Viewport and click Setup |

Communication Settings on the menu to display the “Port Settings” dialog box.

Then click TCP/IP as the connection type. Enter the IP address of the CP2E.

To verify communication, click Diagnostics | Establish Communications (Find

Rack). This should display a dialog box that gives the IP address and port number.

Troubleshooting Communications

Use the following checklist if communication cannot be established with the

CP2/CP2E.

1. Verify that you are using the correct cables. As described previously,

an RS-232 connection requires a straight-through serial cable. That is,

pin 1 on one end is connected to pin 1 on the other end. Pin 2 connects

to pin 2, etc. With a TCP/IP connection, you must use a CAT5 cable

with 8-pin RJ45 connectors.

2. With a serial connection, verify that the correct COM port on the PC

has been selected. Some computers have more than one COM port;

22 • 2-Series Integrated Control Processor: CP2/CP2E Operations Guide - DOC. 5980

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Žádné komentáře

Crestron CP2 Specifikace Strana 26