Release Notes: Crestron Database Release Notes
http://www.crestron.com/release_notes/crestron_database_36_00.html[12/14/2012 4:56:59 PM]
Update to c2n-sdc shade control module
Version 19.01
Added support for new keypads: HTT-B10X, C2NI-CB, INET-CBD, and INETI-CB
Updated modules: TSTAT w/5-2 Scheduler, THSTAT w/5-2 Scheduler, TSTATRF w/5-2 Scheduler
D3Pro database entry: Added support for startup delay of a switched non-lighting load on CLX-4HSW4
Version 19.0.8
Added MPS-300 Protected Modules.
Fixed: Crestron C2N-TXM Hardware Interface v2.0.cmc. After program upload or reset, incorrect power state of
device was possible. Added ability to detect and then power cycle in this error state.
Version 19.0.7
Added support for the C2N-CB-TS. Note: D3Pro v2.5.5 or later required. System Builder v3.03 will only
generate default keypad parameters and will ignore the settings chosen in the keypad properties menu. Non-
default values must be set manually in the generated simpl windows program.
Engraver support for the MPS-300.
Version 19.0.6
Fixed: AES front panel was including the wrong XM module.
Fixed: Engraver was causing SystemBuilder to incorrectly assign programmable hard-buttons on the TPMC-8L.
Fixed: cnctrl2.mdb was wrongly packaged as read-only.
Version 19.0.5
Added full support for CEN-IDOC Search feature. Note: Feature requires firmware version 1.003.0021 or higher.
Added additional Engraver support.
Version 19.0.4
Internal Fixes.
Version 19.0.3
Added full support for RGBHV switchers
Added TPS-6L Cresnet, Ethernet for SB and D3 Pro
Engraver support for C2N-CB-T,S
CHV-TSTAT and CHV-THSTAT modules v3.2
includes a bug fix and new direct setpoint signals
Wrapper module for C2N-CB-TS for use in System Builder and D3Pro
Added scrolling list for AM/FM channels or presets
Allow multiple touch panels to have independent browsing on the same AM-FM tuner.
Added scrolling list support for Adagio Large TP AMFM GUI Interface v2.1 and/or Adagio Small TP AMFM GUI
Interface v2.1 modules.
Version 19.0.2
Added limited support for RGBHV switchers
Added iMedia output cues:
System_Ready_Pulse
Pulses when the system program has finished initializing
Supports_IM-RXVx-M
High if the "Version" console command reports back IM-RXVx-M.
Low for non -M units.
Show_Master_Volume_Subpage
High if "Knob is Master" feedback and "Support_IM-RXVx-M" are both high.
(18 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce