Crestron Cameo C2N-CB Series Instalační příručka Strana 21

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 40
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 20
Crestron C2N/C2NI-CB Series Cameo Keypads
Operations & Installation Guide - DOC. 6560B Cameo Keypads: C2N/C2NI-CB Series 17
After the Cresnet network wiring has been installed and verified, use the
following procedure to install the keypad in a standard, single-gang
electrical box (not supplied).
1. Turn Cresnet system power OFF.
2. Connect the Cresnet cable to the keypad’s Cresnet port, using
the supplied mating connector.
CAUTION: Excess wire pinched between the keypad and electrical box
could short out. Make sure that all excess wire is completely inside the
electrical box and not between the box and the keypad.
3. Attach the ground wire to the ground screw of the electrical
box.
4. Make sure the keypad is oriented properly, place it in the
electrical box, and attach using the supplied 7/8 in. pan head
screws.
Zobrazit stránku 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Komentáře k této Příručce

Žádné komentáře