Crestron Lighting Design Instalační příručka stáhnout pdf (Strana 23)

230 V Lighting Design Guide

Doc. 4859C | crestron.com

Lighting Control Modules

Concealed in Crestron automation cabinets, the CLXI-Series devices are rigorously built using oversized heat sinks

for ultimate reliability.

• Split-bobbin transformers and ground-referenced electronics deliver superior performance.

• Lamp ﬂicker is minimized through the innovative Crestron zero-crossing detection technique, backed by

proprietary ﬁrmware.

• Low-maintenance convection cooling assures quiet and trouble-free operation.

• Noise suppression inductors are available.

• LEDs on the modules indicate communication to a Cresnet network, input power to the module, and output

power to the load.

• A ﬁve-pin ribbon cable interconnects modules and the processor.

NOTE: CLXI modules and their associated CLTI (BN) terminal blocks must be installed into the lowest available

spaces and continue toward the top of the enclosure.

CAUTION: A bypass jumper is provided to allow testing and to protect the module during installation. When properly

secured by nine screws, the jumper on the black and red section of the terminal block shorts the line to the output

so that the circuit is energized. Do not remove the bypass jumper until all feed and load wiring has been completed,

the circuit has been tested for electrical faults, and the module has been installed. The jumper on the white section

of the terminal block ties the NEUTRAL IN to the neutral outputs.

CLXI-Series Device

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 81 82

Žádné komentáře

Crestron Lighting Design Instalační příručka Strana 23