Crestron C2N-FT-TPS4-U Instalační příručka stáhnout pdf (Strana 27)

Crestron C2N-FT-TPS4/TPS4-U FlipTop Touchpanel Control Center

Typical Connection Diagram when Uploading

NOTE: Use a straight-through serial cable for connection to a 2-Series processor.

1. Open Crestron Toolbox and click Tools | Manage Address Book to display

the communications settings. The DefaultAddressBook.adr file contains

several default address settings. Select Serial on COM 1 for serial

communication.

Crestron Toolbox – “Address Book” Window

The PC communication settings specified in the address book should match

the protocol that the control processor expects. The settings are as follows:

• Port = COM 1 through COM 8. Select the correct COM port on the

PC.

• Baud rate = Auto Detect.

• Parity = None.

• Number of data bits = 8.

• Number of stop bits = 1.

• Hardware handshaking (RTS/CTS) enabled.

• Software handshaking (XON/XOFF) not enabled.

Operations & Installation Guide – DOC. 6398 FlipTop Touchpanel Control center: C2N-FT-TPS4/TPS4-U • 23

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Žádné komentáře

Crestron C2N-FT-TPS4-U Instalační příručka Strana 27