Crestron STRFGWX Specifikace stáhnout pdf (Strana 30)

2-Way RF Wireless Touchpanel Crestron STX-1700C

STX-1700C Troubleshooting (continued)

TROUBLE

POSSIBLE

CAUSE(S)

CORRECTIVE ACTION

Touchpanel operation

appears unreliable.

Touchpanel is out of

range. Refer to "Out

Bring unit within range. Refer to

"Specifications" for details.

of Range Feature"

below.

Use reserved join number 17509 in SIMPL

Windows program to indicate when touchpanel

is out of range.

Install an additional STRFGWX near the area

of use to accommodate roaming.

RF Interference Test as wired unit. If unit tests OK as wired

touchpanel, and fails as wireless touchpanel,

call Crestron Customer Support.

Touchpanel does not

function and SIG LED

on STRFGWX

illuminates, but Rx or

Tx LEDs do not.

Touchpanel RF ID is

not set to match the

RF ID assigned in the

control system

program.

Verify that RF IDs match. Refer to the "Select

Interface" on page 8 for details and RF ID

parameters assigned in the program.

Touchpanel screen

changes without

touching screen or

buttons.

Touchpanel went out

and then in range

while control system

changed a screen.

Use reserved join number 17509 in SIMPL

Windows program to indicate when touchpanel

is out of range.

Out of Range Feature

The following describes touchpanel operation when the out of range feature is active

or not active. Crestron recommends that you use the out of range feature.

Out of Range Feature Active

When the STX-1700C is out of range, it displays an out of range indication of your

choice (refer to Reserved Join Numbers on page 23), and the touchpanel does not

respond. Also the STRFGWX’s TXD (transmit) LCD will flash every 4 to 5 seconds

for approximately 30 seconds and then the LCD stops flashing (the unit stops

transmitting if the touchpanel does not come into range in the allotted time). If the

touchpanel comes into range BEFORE the STRFGWX stops transmitting, the

display reverts to whatever screen the control system has active. If the touchpanel

comes into range AFTER the STRFGWX stops transmitting, the user must touch the

screen to activate the gateway and leave the out of range screen.

Out of Range Feature Not Active

When the STX-1700C is out of range, there is no out of range indication displayed.

The only noticeable symptom on the touchpanel is that it does not respond. The

STRFGWX’s TXD LCD will flash every 4 to 5 seconds for approximately 30

seconds, and then the LCD stops flashing (the unit stops transmitting if the

touchpanel does not come in range in the allotted time). If the touchpanel comes into

range BEFORE the STRFGWX stops transmitting, the touchpanel will start

responding and the display reverts to whatever screen the control system has active.

If the touchpanel comes into range AFTER the STRFGWX stops transmitting, the

user must touch the screen to activate the gateway. The screen may change if the

control system sent a change to the touchpanel during the time it was out of range.

• 2-Way RF Wireless Touchpanel: STX-1700C Operations Guide - DOC. 6049

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Komentáře k této Příručce

Žádné komentáře

Crestron STRFGWX Specifikace Strana 30

Komentáře k této Příručce

Související produkty a manuály pro Brány / ovladače Crestron STRFGWX