Crestron TPMC-10-DSW Instalační příručka stáhnout pdf (Strana 10)

Docking Assembly for TPMC-10 Crestron TPMC-10-DSW

Installation

To install the TPMC-10-DSW, complete the following procedure in the order

provided. Tools required are a #2 Phillips screwdriver and a 9/64-inch Allen wrench.

NOTE: The TPMC-1-DSW is designed for mounting in a vertical configuration

only. Do not mount in a lectern or desktop configuration.

1. Prepare a cutout in the wall, centered between two studs, located on

16-inch centers. The hole should be 13 inches wide, and 11 inches high.

Refer to the following drawing.

(Depending on the accuracy of the stud spacing, it may be desirable to

prepare the cutout directly adjacent to one stud, and attach an extra

section of stud material to the stud on the other side of the opening.)

Wall Cutout Location and Dimensions

13 in

(33 cm)

11 in

(28 cm)

STUD STUD

CUT ALONG

LINE

2. Check that the Cresnet wiring is installed in the wall and verified.

3. Refer to the following illustration and remove and retain the four

screws securing the cover plate to the docking assembly. Lift the cover

plate from the assembly.

Docking Assembly Cover Plate Removal

Screws

Cover

Plate

6 • Docking Assembly for TPMC-10: TPMC-10-DSW Operations and Installation Guide - DOC. 6400

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Žádné komentáře

Crestron TPMC-10-DSW Instalační příručka Strana 10