Crestron C2N-FTB Instalační příručka stáhnout pdf (Strana 11)

Crestron C2N-FTB-D FlipTop Control Center, Dual AC Outlets

Connectors, Controls & Indicators

CONNECTORS*,

CONTROLS &

INDICATORS

DESCRIPTION

1 KEYPAD

Programmable keypad allowing variable

combinations of large and small engravable

buttons, 10 minimum (all large) to 20

maximum (all small); ships with 10 large

buttons (small buttons and engraving sold

separately)

(1) red LED per button, programmable.

2 PWR

(1) Green LED, indicates 24 Volts DC power

supplied from Cresnet control network.

3 NET

(1) Yellow LED, indicates communication

with Cresnet system.

4 BAR GRAPHS

(2) Red 8-segment LED bar graphs,

programmable.

125V

(2) Grounded AC sockets, AC power pass

through outlets;

Maximum load: 10 Amps (total) @ 120 Volts

AC, 50/60 Hz

125V

(1) 9 foot grounded AC line cord; passes

through to front panel AC power outlets.

NET

(2) Four-position terminal block connectors

for data and power. Connect to Cresnet

control network.

Pin 1 (24) Power (24 Volts DC)

Pin 2 (Y) Data

Pin 3 (Z) Data

Pin 4 (G) Ground

8 SETUP

(1) Miniature pushbutton and red LED, used

for touch-settable ID (TSID)

Used for setting network ID during initial

configuration or when the device is being

added/replaced.

(1) 6-32 screw, chassis ground lug.

* Interface connectors for NET ports are provided with the unit.

Operations & Installation Guide – DOC. 6639B FlipTop Control Center, Dual AC Outlets: C2N-FTB-D • 7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Komentáře k této Příručce

Žádné komentáře

Crestron C2N-FTB Instalační příručka Strana 11

Komentáře k této Příručce

Související produkty a manuály pro Numerické klávesnice Crestron C2N-FTB