Crestron C2N-FTB Instalační příručka stáhnout pdf (Strana 20)

FlipTop Control Center, Dual AC Outlets Crestron C2N-FTB-D

NOTE: The maximum continuous current from equipment under any external load

conditions shall not exceed a current limit that is suitable for the minimum wire

gauge used in interconnecting cables. The ratings on the connecting unit's supply

input should be considered to prevent overloading the wiring.

NOTE: Ensure the unit is properly grounded.

Ground Wire Connections

Proper grounding is required. Connect the ground from the C2N-FTB-D to earth

ground. Connect the Cresnet shield lead at the control processor to the ground lead.

The control processor chassis must also be connected to an earth ground (building

steel). Refer to the following grounding diagram.

Ground Wire Connections

Shield

Ground Wire to

Earth Ground

Ground Wire to

Earth Ground

Cresnet

Control

Processor

C2N-FTB-D

NOTE: Do not connect the shield to earth ground at the C2N-FTB-D.

16 • FlipTop Control Center, Dual AC Outlets: C2N-FTB-D Operations & Installation Guide – DOC. 6639B

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Žádné komentáře

Crestron C2N-FTB Instalační příručka Strana 20