Crestron CHV-RSS Instalační příručka stáhnout pdf (Strana 5)

Crestron CHV-RSS Remote Slab & Outdoor Temperature Sensor

Installation Guide – DOC. 6229D Remote Slab/Outdoor Temperature Sensor: CHV-RSS

•

Remote Slab Sensor and Outdoor

Temperature Sensor: CHV-RSS

Introduction

The CHV-RSS is a remote temperature sensor designed for use with

select Crestron

thermostats. Ideally suited for concrete slab, under floor,

or any outdoor installation, the CHV-RSS is an extremely accurate

temperature sensor potted within a rugged waterproof stainless steel

sleeve. Using CAT5 or similar low capacitance wire, the remote sensor

may be mounted up to 500 feet (153 meters) from the thermostat.

One-piece mounting and a single non-polarized twisted-pair connection

make the CHV-RSS simple to install. Up to four CHV-RSS sensors may

be connected to a single CHV-THSTAT, CHV-TSTAT, CHV-STATEX

or CHV-TSTATEX-FCU thermostat (all sold separately).

NOTE: When connecting a CHV-RSS sensor to a CHV-THSTAT or a

CHV-TSTAT (models without infiNET EX

), note the following

firmware differences:

• Thermostat firmware version 1.xx supports two optional remote

sensors. Thermostat firmware version 2.xx and later supports four

optional remote sensor inputs, in any combination, for each

thermostat.

• Firmware version 2.xx and later is required if the CHV-RSS is to

be used as a slab temperature sensor. Any firmware version may be

used to operate the CHV-RSS as an outdoor temperature sensor.

NOTE: If the maximum number of sensors is exceeded, some of the

sensors will be ignored by the system.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Žádné komentáře

Crestron CHV-RSS Instalační příručka Strana 5