Crestron CHV-TSTATEX Instalační příručka stáhnout pdf (Strana 49)

Crestron CHV-TSTAT and CHV-THSTAT Thermostats

Operations and Installation Guide – DOC. 8163E Thermostats: CHV-TSTAT and CHV-THSTAT

•

Slab 3 – 1-Stage Heat with Slab Minimum/Maximum

Press and hold the MODE and VIEW buttons simultaneously for 5 seconds to enter setup mode.

SETUP: SYSTEM

Heat Sys Type:

Slab MAX T:

Slab Reg:

SLAB 3

122

1 STG SPACE HEAT BY SLAB

WITH SLAB MIN/MAX (W1)

Press To Continue

Heat Sys Type: SLAB 3

Slab MAX T: Select 39° – 122° F (39° – 50° C). Used to

prevent the floor from becoming too hot on long heat calls.

Slab Reg: Select 1 – 6.

1 = Narrow temperature regulation

6 = Wide temperature regulation

NOTE: Slab mode 3 requires an air temperature source and

a slab remote sensor (CHV-RSS, sold separately).

SETUP: SYSTEM PERFORMANCE

SETUP: SYSTEM PERF

Heat Anticipator:

ADJUSTS HEAT SHUTOFF DYNAMICS

Press To Continue

Heat Anticipator: Select 1 – 6.

Low number = more frequent cycles, faster response.

High number = less frequent cycles, slower response.

SETUP: HUMIDITY OPTIONS

SETUP: HUM OPTS

Show Hum Mode Pg:

Show Hum View Pg:

Cold Weather Comp:

SYSTEM ENABLE/DISABLE

PAGE

SETUP: HUM OPTS

Invert Hum Output Y

Call FAN in HUM: N

INVERTED HUM RELAY LOGIC

HUM ABOVE SP = ENERGIZED

Press To Continue

Show Hum Mode Pg and Show Hum View Pg: Select Y to show

humidity page in normal operation.

Cold Weather Comp: Modifies the humidifier output to prevent

condensation on the windows. Requires an outdoor temperature

source (CHV-THSAT or CHV-TSTAT with CHV-RTHS,

CHV-RTS or CHV-RSS, sensors sold separately).

Invert Hum Output: Reverses the logic controlling the switching

of the HUM relay (NO/NC). May be useful when using to

control a dehumidifier.

NOTE: Most dehumidifier applications require the default

setting.

Call FAN in HUM: Makes a fan call during humidity calls

instead of waiting for a heating or cooling call to trigger the fan.

NOTE: Most dehumidifier applications automatically trigger

fan operation.

NOTE: This setting is only useful for humidity calls with

normal (non-inverted) logic.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 91 92

Komentáře k této Příručce

Žádné komentáře

Crestron CHV-TSTATEX Instalační příručka Strana 49

Komentáře k této Příručce

Související produkty a manuály pro Termostaty Crestron CHV-TSTATEX