Crestron CHV-TSTATEX Instalační příručka Strana 71

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 92
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 70
Crestron CHV-TSTAT and CHV-THSTAT Thermostats
Operations and Installation Guide DOC. 8163E Thermostats: CHV-TSTAT and CHV-THSTAT
65
Mode Button Menus
Heat/Cool, Heat Pump and Slab 4 Systems
Pressing the MODE button allows the user to access the following screens when the thermostat is
configured for Heat/Cool, Heat Pump and Slab 4 Systems.
System ModeScreen
MODE
VIEW
System Mode
HEAT COOL AUTO OFF
AUX HEAT ONLY
The “System Mode” screen appears when the MODE
button is initially pressed.
Use the up ▲and down arrow buttons to select HEAT,
COOL, AUTO, OFF or AUX HEAT ONLY.
NOTE: The AUTO selection allows the system to switch
between heat and cool automatically as needed to maintain
the temperature.
NOTE: The AUX HEAT ONLY is for the backup heating
system on heat pump based systems only. It allows the
backup system to operate without operating the heat
pump.
Fan ModeScreen
MODE
VIEW
Fan Mode
AUTO ON
Pressing the MODE button again displays the “Fan Mode”
screen.
Use the up ▲and down▼arrow buttons to select AUTO or
ON.
NOTE: In AUTO, the fan runs only when the system calls
for heat or cool. In ON, the fan runs continuously.
HumidifierScreen
MODE
VIEW
Humidifier
ENABLED DISABLED
Pressing the MODE button again displays the
“Humidifier” screen.
NOTE: This page only appears if enabled in the “HUM
OPTS” setup screen.
NOTE: CHV-TSTAT requires additional remote humidity
sensor (CHV-RTHS, sold separately).
Use the up ▲and down ▼arrow buttons to select
ENABLED or DISABLED.
Zobrazit stránku 70
1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 91 92

Komentáře k této Příručce

Žádné komentáře