Crestron CT-1550 Specifikace stáhnout pdf (Strana 11)

Crestron CT-1550 Wired 5.7 Inch Tabletop Touchpanel

Operations Guide – DOC. 6116A Wired 5.7 Inch Tabletop Touchpanel: CT-1550 • 7

Calibration Menu

NOTE: Calibration works best

when performed with a narrow,

blunt instrument (i.e., pencil eraser).

Calibration of the touchscreen is required if the active touch area of a button does

not coincide with the button’s image. Select the Main Menu TOUCH SCREEN

CALIBRATION button to display the Calibration Menu, shown to the left. Select

the Perform Calibration button to initiate “calibration mode.” The touchpanel

prompts you with a message, “Touch Upper Left Corner.” Touch the corner of the

screen; be as accurate as possible. Another message, “Touch Lower Right Corner,”

appears. Perform the operation to complete calibration and return to the Main Menu.

Pressing the Return to Main Menu button at any time before completing calibration

returns you to the Main Menu without changing any settings.

NOTE: When touching each location during calibration, be as accurate as possible.

Use the tip of a capped pen or the eraser end of a pencil. To cancel calibration and

return to the Calibration Menu without saving calibration data, create an error

condition by touching the screen in an area that is opposite from the instructed area.

Setup Menu

To obtain the Setup menu, shown to the left, touch the SETUP

utton from the Main

Menu. Many options for setting parameters of the touchpanel are available from the

Setup menu and are explained in the following paragraphs. After these parameters

have been set, press the RETURN button to return to the opening screen.

Contrast

Screen contrast may need to be altered because of ambient light conditions, viewing

angle, panel temperature, or personal preference. The CONT <<, and CONT >>

buttons adjust the screen contrast to a desired level. The buttons may be held down

for continuous and smooth adjustment of the screen.

Panel Tracking

Panel tracking is a useful communication feature between touchpanels when more

than one touchpanel exists on the network. Panel tracking is enabled when the

PANEL TRACKING button is selected. When enabled, a page change to any

touchpanel on the network forces the same page change to all enabled touchpanels.

Panel tracking is disabled when the PANEL TRACKING button is deselected.

Panel tracking is factory set with PANEL TRACKING deselected.

Brightness

Screen brightness may need to be altered because of ambient light conditions or

personal preference. The BRT LOW, BRT MED, and BRT HI buttons let you

choose from among three pre-set levels of screen brightness.

Backlight Timeout

Backlight Timeout Screen

The Backlight Timeout screen, shown to the left, appears when you press the

MANAGE POWER button on the Setup menu. Turning off the backlight when the

touchpanel is inactive can extend the life of the display hardware. When the

touchpanel is activated following a timeout, the last screen to be displayed reappears.

The default timeout value is displayed in the top portion of the screen, as shown. Use

the DOWN and UP buttons to change the value. Backlight Timeout can be set

between 0 and 120 minutes. The SAVE TIMEOUT button saves the current value.

Pressing the RETURN button returns you to the Setup menu.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Komentáře k této Příručce

Žádné komentáře

Crestron CT-1550 Specifikace Strana 11

Komentáře k této Příručce

Související produkty a manuály pro ne Crestron CT-1550