Crestron CT-1550 Specifikace stáhnout pdf (Strana 12)

Wired 5.7 Inch Tabletop Touchpanel Crestron CT-1550

8 • Wired 5.7 Inch Tabletop Touchpanel: CT-1550 Operations Guide – DOC. 6116A

NOTE: Display backlight requires warm-up time to reach full brightness.

Interface Menu

The touchpanel communicates with a control system to activate other controls or to

display feedback from components within the system. The communication interface

must be correctly specified or communication will not occur. To set communication

parameters, select the INTERFACE button from the Setup Menu to display the

Interface Menu, shown to the left.

The Cresnet network identity number (Net ID) is displayed in the top portion of the

screen. Net ID consists of a two-digit hexadecimal number ranging from 03 to FE.

This setting and the Net ID set in the SIMPL Windows program must match.

Matching Net IDs between touchpanel and program are required if data is to be

successfully transferred or new touchpanel screens are to be loaded. Net ID is

factory set to 03.

Sound Menu

The touchpanels are equipped with audible feedback that can be turned on or off and

have its volume adjusted. To obtain the Sound Menu, shown to the left of this

paragraph, touch the SOUND button from the Setup Menu. The KEYCLICK ON

and KEYCLICK OFF buttons activate and deactivate the audible feedback,

respectively. The VOLUME UP and VOLUME DOWN buttons increase and

decrease the sound’s volume, respectively. A sample of sound volume is emitted

with each incremental press. Touch the Return button, located at the bottom of the

menu, to save the settings and display the Setup Menu.

Diagnostics Menu

The DIAGNOSTICS button on the Main Menu should only be used under

supervision from a Crestron technical support representative during telephone

support. The options available from the Diagnostics Menu, shown to the left, are

beyond the scope of this manual.

Hardware Hookup

CAUTION: Do not apply excessive pressure to the touchscreen display during

handling. Doing so can crack the screen and damage the touchpanel.

The CT-1550 touchpanel has rubber pads on the underside of its base so that it can

rest on a horizontal surface. The only connection necessary is made to the 6-pin

RJ-11 connector mounted in the bottom of the unit base. The Crestron CN-RJ11

4-wire to RJ-11 Converter and a 12-foot interface cable are supplied to convert a

4-pin Cresnet connection on the control system to the 6-pin connection in the

touchpanel.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Žádné komentáře

Crestron CT-1550 Specifikace Strana 12